Corby 36201011m

Safety:
Fortress aluminium folding anchor
Chain and anchor warp
Radar reflector
Jack lines
3 double tethers with overload indicator
5 single tethers
Horseshoe float with boat name
Johnbouy – danbuoy

Engine:
Model Lombardini LDW1404M
Sail drive with 2 bladed folding propellor

Below Deck:
4 x Flush closing through hulls
Jabsco Manual toilet
Duel burner gas hob
55L flexible freshwater tank
Fresh and saltwater pump taps in carbon sink
3 x powder fire extinguishers & Fire blanket
Bunk Cushions mid and aft
2 pipe cots

Deck Hardware:
6 x Spinlock xx0812, power clutches for spinnaker, genoa, main halyard and tack lines
2 x Spinlock 0814 jammers with ceramic Jaws
2 x Harken primary 3 speed racing winch B50.3STR-FD
2 x Harken 46, 2 speed cabin top winches with cross sheeting base
2 x Harken 40, 2 speed mainsheet winches
4 harken long winch handles
2 short winch handles
Harken main track and harken turning blocks below deck traveller purchase
Genoa tracks with adjustable 12:1 up/down and 8:1 side to side internal purchase
Hydraulic Backstay control with main trimmer up and down lines
Karver spinnaker staysail furler
Harken reflex unit 1 code zero furler
Equiplite mast base blocks
Harken spinnaker blocks
Deck rope bags at mainsheet and primary’s
Under deck halyard bags @ hatch

Electronics:
B&G H5000 Hercules CPU with Performance software upgrade from Hydra software
B&G H5000 Autopilot with 2 x WR 10 pilot remotes
Mast 3 X Garmin GNX 120 7inch multi displays on H5000
2 x B&G Graphic display units in cockpit
B&G Zeus2 12inch Plotter at chart table with charts
B&G ZG100 GPS antenna compass
Carbon VM HU
B&G Precision compass
B&G DD-15 rudder feedback
B&G Autopilot pilot ram
B&G V50 VHF
B&G ais-400 - AIS in and out
Moax network hub & Wi-Fi B&G access point displaying on tablet or phone
B & G VHF antenna
B & G Wind wand
Fusion MS-RA50 Radio with 2 cockpit Loudspeakers
1 X 110AH service battery
1 x 75AH engine battery

Mast & Rigging:
Marstrom Carbon Mast with Nitronic Rod Rigging,
Carbon Boom
Harken Carbo head foil
Hydraulic mast jacks and pump in box with large selection of shims
Short Carbon bowsprit
Long Carbon bowsprit with mid and end tack points
Carbon Spinnaker pole
Carbon tiller arm
Aluminium tiller arm

2 Masthead Spinnaker halyards
2 jib halyards
2:1 main halyard
Staysail halyard
2 x tack lines
2 x Spinnaker sheets
1 x peel spinnaker sheet
2 x Spinnaker guys
5 x Jib sheets
Continuous mainsheet
Spinnaker staysail sheets

A spectacular ‘no expense spared original build’, with a full inventory and a very recent refit gives superb value for money.

Oui (Originally Inga from Sweden) was built in 2010 by Richard Goransson to race IRC in Sweden.

Hull Material/Construction: Composite hull, Cedar strips planks scarfed together, then faired, sheathed in carbon fibre,
Finish; Hull fully faired and painted with Awlgrip paint.
Hull bottom antifouled and polished.
The superstructure is a carbon fibre/foam sandwich composite.
Carbon used in reinforcement areas internally.

Length overall 11.02 m
Beam 3.15 m
Displacement 4956 kg
Draft 2.29
Engine 1 x Lombardini
Fuel Diesel
Hull Composite
Location Cowes, UK

North Sails
2015
Mainsail (2reefs 3DL 50/50 aramid carbon 16800 DPI)
A4 Gennaker (SK150)

2014
Mainsail (1reef 3DL 50/50 aramid carbon 16800 DPI)
J1.5 Jib (3DL 50/50 aramid carbon 14700 DPI)
J2 Jib (3DL 50/50 aramid carbon 16800 DPI)
J3 Jib (3DL 50/50 aramid carbon 22400 DPI)
A0-3 Code Zero (CZ30)
A1 Gennaker (SL50)
S2+ Spinnaker (SK90)
S2 Spinnaker (SL60)
Storm Jib
Trysail
JibTop
Spin Staysail
Jib Top staysail